MAK-90 with Polytech "Pre-Ban" Barrel
Some of you have been asking questions again about whether the barrels offered by Polytech will fit the MAK-90.
The answer is yes, but you have to:
- Cut the breech for the extractor
- Drill and pin the barrel
- Mill the relief for the handguard retainer
- Drill the gas port
- Drill and pin the FSB
- Requires the early version of the Chinese bayonet
![]()
![]()
![]()
![]()
The answer is yes, but you have to:
- Cut the breech for the extractor
- Drill and pin the barrel
- Mill the relief for the handguard retainer
- Drill the gas port
- Drill and pin the FSB
- Requires the early version of the Chinese bayonet
4
